![]() ![]() user accounts based on the need of remote workers. Network manager sets up VPN Virtual private network - A network that enables users connect securely to a private network over the Internet. Network manager sets up Kerio Control and gets the IP address or name(s) of the Kerio Control Server. Here is a summary of what is required in terms of configuration: For more information refer to Configuring network interfaces. To change the automatic pre-configuration, go to Kerio Control Administration to section Interfaces. where Kerio Control is accessible from your LAN.Īfter finishing the wizard, Kerio Control displays the login page. To perform the initial setup, open the following address in your webīrowser: for example, which is the IP address An identifier assigned to devices connected to a TCP/IP network.Follow the instructions on the computer's console to perform the.Y is 1 for the Control interface and 11-254 for DHCP assigned hosts. Kerio Control runs its own DHCP server through all LAN interfaces configured to 10.10.X.Y where X is the index of the LAN interface (starting with 10). interfaces - All interfaces without any detected DHCP server. LAN Local area network - A network that connects computers and other devices in a small area.If there is more than one Internet interface with a default route, Kerio Control arranges the Internet interfaces in the load balancing mode. Internet interfaces - All interfaces where Kerio Control detects the DHCP server and the default route in the network.server in the network and the DHCP server provides a default route after the installation: Kerio Control checks all interfaces for a DHCP Dynamic Host Configuration Protocol - A protocol that automatically gives IP addresses and additional configuration to hosts in a network. ![]() Use the ISO image to create a bootable USB flash disk.Any existing operating system and files on the target hard disk will be erased.
0 Comments
Leave a Reply. |